TI HOD/LOD Camarilla scanners

[Roberto 10]

Just getting this up quick to share, will elaborate later.  Running most scanners against a small list of high $ stocks.

This is a four screen layout, not sure how it will load, try it.

 

https://www.trade-ideas.com/Cloud.html?code=d2676e9684f6bd4e0ccd7ab3211b6987

MAJOR EDIT:  TI won't copy my custom formulas, so you'll need to enter these by hand.  Uploading now.

Edited March 3, 2021 by Roberto

[Roberto 10]

Just need the R4 through S4 (U0-U8), but keep the Uxx the same, or you'll need to change them in the scanners.

Edited March 3, 2021 by Roberto

[Roberto 10]

Main screen, my scanners are the block of 16 anchored lower left corner:

[Roberto 10]

Here's my current list of LOH/HOD tickers that I'll adjust as I see fit.  The two alert windows on the right are my main triggers, and have voice alert.  The main page above is general info that I'm evaluating for usefulness.

Edited March 3, 2021 by Roberto

[trader77 1]

Good works!

I will give a try about your cam scanner tomorrow to see if we can find good setup.

I've tried ton find a cam scanner but without success.

TY!

[Roberto 10]

Good luck. I only run these scanners against my own custom symbol lists, so you might need to think about how to filter what you want to see.

[trader77 1]

Do you know how can i change the formula in the scanner because i can't find where.

 

[trader77 1]

ok I've found it but where can i add the icon next to U0 in the formula for example???

[Roberto 10]

Those symbols autopopulate when you fill in the correct code. The one you are looking at is for price.

[Price]

Edited April 7, 2021 by Roberto

[trader77 1]

ty will try that 

[trader77 1]

rmg hod/rmg lod works if i try yesterday data but all the S4 under until R4 over doesn't populate if i click on yesterday data.

I don't know what's happened because i've entered the same exact formula with the exact Uxx.

[trader77 1]

Ok i've got it. I must select all symbols> Symbol lists in the config windows of each alert.

Ty

[Roberto 10]

Let me know what you think of it if you try it.

[trader77 1]

The problem is that when i select all symbols, at 10:28 i've got ton of alerts LOL

I think i must create some filter with volume ratio, volume spike in 5min, price, float and an alert when the price is near a camarilla points with volume unusually strong (like the docx from matt.c in this forum i know you've answered on this subject).

[trader77 1]

It would be great to have a scanner like this :

yesterday close price is above yesterday pivot range(>R1) AND today's open price is above pivot range(>R1) bullish bias - populate the windows just at the open

yesterday close price is below yesterday pivot range(<S1) AND today's open price is below pivot range(<S1) bearish bias - populate the windows just at the open